Jfc I have to rant: instead of ~30min - 1h that this usually would take, it takes ages because for some reason one hole is not only super tight, but also has a ton of thermal mass behind it. So I have to apply heat for 30s and then still not get the old solder out. Only way is to heat it up with fresh solder and then wiggle the leg in.
So, JP18 disables the onboard graphics chip. Making the use of a separate ISA VGA card possible
The board is from a Mitac Paragon MPC2000SL, it has a label of "PWA-286SL", but there is zero documentation of it on the internet. The version with VGA instead of this Paradise EGA chip is called MPC2000VE and that was sold, for a short while in Western Europe, as an Atari PC4. More on that here: https://www.atari-computermuseum.de/pc4m.htm
JP18 on this board disables the onboard graphics and is near the graphics chip. On the SL the jumper is in the very front. The trace however runs all the way to the back, and lo and behold, it does turn off the onboard graphics. Who knows, maybe the other jumpers are identical in function too?
JP18 on this board disables the onboard graphics and is near the graphics chip. On the SL the jumper is in the very front. The trace however runs all the way to the back, and lo and behold, it does turn off the onboard graphics. Who knows, maybe the other jumpers are identical in function too?
Can anyone recommend a Bluetooth sound output module that isn't total jank but also doesn't break the bank?
This media is not supported in your browser
VIEW IN TELEGRAM
This hard drive is loud. (Flicker warning)