Red Alert Media 🚨📢🚨 – Telegram
Red Alert Media 🚨📢🚨
135 subscribers
28.9K photos
16.2K videos
45 files
10.1K links
Memes and More
Download Telegram
Forwarded from Phil Milsom
I tried out hugelkultur method last spring it worked great. Wood buried in the bottom half of these beds acts like a water battery, partially rotten wood is best. It also harbours beneficial fungi and releases nutrients
Forwarded from Woody
This diagram illustrates a thermosiphon system for connecting a wood stove to a water heater, utilizing the stove's heat to warm water without requiring electricity. The setup includes a pressure temperature relief valve (1) for safety, releasing water if pressure or temperature exceeds safe limits. The system starts with a new water heater drain (2) and uses dielectric unions (3) to prevent galvanic corrosion between dissimilar metals. Copper piping (4) slopes uphill from th…
Forwarded from Indian Trucks Kill Canucks 🇨🇦 (Bryan)
This media is not supported in your browser
VIEW IN TELEGRAM
The next German Chancellor claims the decision to admit Ukraine has already been made and Trump cannot stop it. Friedrich doesn’t seem to know any single NATO country can block another country from joining the alliance.

RETVRN OF THE KING
Forwarded from David Avocado Wolfe
Lyme’s disease was created by Dr Erich Traub in Plum Island, New York laboratories, an Operation Paperclip Nazi. His specialty was “gain of function” on tick-borne diseases.

This disease has destroyed the lives of millions of people and was completely denied by the big pharma Rockefeller medicine system.

Join: @davidavocadowolfe 🥑
Please open Telegram to view this post
VIEW IN TELEGRAM
Forwarded from Working Men Memes (Wesla Johnkowski)
Drilling and Tapping threaded holes.

Because the thread angle is 60degrees... and the COS of 60 is 0.5, each side of a bolt's thread is 1/2 of the pitch distance. It means you just subtract the thread pitch from the bolt diameter to get the pilot size. It means that a M5 x 0.8 bolt has a pilot hole size of 5 - 0.8 or 4.2.

Thanks to 60 degree threads, you take the major diameter and subtract the threads per mm or threads per inch to get the pilot hole diameter.

Metric is easy... M6 x 1.0 is 6 minus 1 = 5mm pilot hole.

SAE... 1/4-20 thread. Convert 1/4 to decimal. Convert 1/20th to decimal. Subtract 0.25 - 0.05 = 0.20 . Go to drill index and find there is no 0.20 drill but a Number 7 drill is 0.201. Easy! right?????