Zero tolerance Machining with the Wire-EDM👍

@Solidworks2019

〽️Quick access links toTutorial video posts👇👇

1) MoldDesign
2) Sheet Metal Design
3) Mesh Tools
4) Tools Suite
5) Design for Mechatronics
6) Surfacing
7) Mastercam for SOLIDWORKS
8) Certified SOLIDWORKS Professional
9) SOLIDWORKS 2020 Essential
Training

#Links
#Tutorial_Videos

@Solidworks2019

Machining Design Guidelines
📌 Milling Guidelines

✅Narrow Regions in Pockets
It is recommended to avoid features that are too close to each other such that the gap between them is too narrow to allow milling cutter to pass through them. If narrow regions areunavoidable, then they should not be very deep.
The size of the milling cutter is constrained by the smallest distance between the faces of the feature.
Small diameter cutters are prone to breakage and chatter. Hence larger diameter, shorter cutters are generally preferred.

SolidWorks Drawing Tutorial

✅ Sub: Custom Sheet Format

#Tutorial_Videos
#SolidProfessor

@Solidworks2019

SolidWorks Drawing Tutorial

✅ Sub: Custom Properties and Parametric Notes

#Tutorial_Videos
#SolidProfessor

@Solidworks2019

SolidWorks Drawing Tutorial

✅ Sub: Formatting Dimensions

#Tutorial_Videos
#SolidProfessor

@Solidworks2019

Machining Design Guidelines
📌 Milling Guidelines

✅ Sharp Internal Corners

Rounded corners provides number of advantages such as less stress concentration on part and tool,few operational steps and reduced scrap rate.
Sharp inside corners cannot be produced by milling and require more expensive machining methodslike EDM. When designing a three-edged inside corner, one of the inside edges should be radiused. It is advised to avoid sharp corners and use fillets and radii.

Examples 👇✅❌
@Solidworks2019

related to Sharp Internal Corners post :

📌 If a sharp corner is required for mating clearance, then drilling a separate relief hole as shown below may serve the purpose.

#Tips
#milling

@Solidworks2019

Render By Amirreza Shayan🔥
ID : @Amirreza_shayann
#Keyshot

SolidWorks Assembly (Mates) Tutorial

✅ Sub: Adding Mates

#Tutorial_Videos
#SolidProfessor

@Solidworks2019

SolidWorks Assembly (Mates) Tutorial

✅ Sub:Distance Mate

#Tutorial_Videos
#SolidProfessor

@Solidworks2019