Alright, it's back in the printer. 'Round 10 o'clock the print should be ready, and we'll see if I've won this battle!

https://www.youtube.com/watch?v=f9Lgj8vKBGA Whelptunes for everyone!

The print should be ready in an hour and 18-ish minutes. We'll see if I've won the day or if I'll spend the night fighting the model some more.

It was covered in supports. I missed half the SMN movie. My workspace is a mess. But I did it... the day is won. The dragon ornament is in the wash. Swishing around in the cleaning fluid. After it dries out tomorrow, it can go in the curing station. Have some whelptunes. https://www.youtube.com/watch?v=nJVFZXzDHPo&pp=ygUcdHdpbGlnaHQgZm9yY2UgbWFkZSBvZiBzdGVlbA%3D%3D

I think some finer details got lost. But it should be fine.

The day is won. Behold. Tomorrow I will throw it in the curing station and it will be safe to handle and spraypaint. Then paint up some day when the air in the shed makes it safe to do so (and assuming I have all the paints I need.) But I think this will be enough printing for the next few days. I'm running out of surgical gloves. Safety is very important!

The day is won. Behold. Tomorrow I will throw it in the curing station and it will be safe to handle and spraypaint. Then paint up some day when the air in the shed makes it safe to do so (and assuming I have all the paints I need.) But I think this will be enough printing for the next few days. I'm running out of surgical gloves. Safety is very important!

The blender saves took up FIFTY GIGABYTES on my harddrive!!!!!1!1!!!oneone!!!

It is time to go put the print in the curing station.

I cannot print anything else for the weekend. I do not have any protective gloves or absorbant paper towel. It was quite a mess back there, so I used the last of my surgical gloves and paper towel to clean it all. Have some Whelptunes! https://www.youtube.com/watch?v=o9RlSQXkZ6Q&pp=ygUiZnJlZWRvbSBjYWxsIHRoZSBsYW5kIG9mIHRoZSBsaWdodA%3D%3D

https://skribbl.io/?cECzKGel come play Skribble with us!

My cousin wants me to build a cucumber beetle trap with my 3D printer. Hmm...

Current project: 3D print a Cucumber Beetle trap. I am skeptical of this, since resin models, after being cured, stink something terrible. Maybe the yellow paint will disguise it?

https://www.youtube.com/watch?v=B8l1M5AJQKk&pp=ygUOS1ogTmVjcm9tYW5jZXI%3D Some whelptunes, appropriate for my sinister machinations of insect destruction.