Forwarded from (️️*Prometto️*)
01_BGP_Questions_MCQ's_Part1_ATech
390.9 KB
Forwarded from (️️*Prometto️*)
03_BGP_Questions_MCQ's_Part3_ATech
369.3 KB
Forwarded from (️️*Prometto️*)
️OSPF Questions (MCQ's) - Part1-2 ️🔰〽️
Forwarded from (️️*Prometto️*)
01_OSPF_MCQ's_Part_1_ATech_Waqas
329.7 KB
Forwarded from (️️*Prometto️*)
02_OSPF_MCQ's_Part_2_ATech_Waqas
309.6 KB
User Datagram Protocol (UDP)
مفهوم UDP به شکل متنوع
https://ccnaeducation.com/user-datagram-protocol-udp/
@CiscoInterface
مفهوم UDP به شکل متنوع
https://ccnaeducation.com/user-datagram-protocol-udp/
@CiscoInterface
Get in the zone! #DevNet Zone, that is 😏 New Cisco certifications have been announced for engineering and software… https://t.co/qRLmFKYNHI
@CiscoInterface
@CiscoInterface
Twitter
Cisco
Get in the zone! #DevNet Zone, that is 😏 New Cisco certifications have been announced for engineering and software - learn more! https://t.co/DoclrtGB51 #CLUS
Refer to the exhibit what is the most efficient summorization that R1 can use to advertise its networks to R2 ?
Anonymous Poll
27%
A. 172.1.0.0/22
36%
B . 172.1.0.0/21
27%
C . 172.1.4.0/22
9%
D. 172.1.4.0/24
0%
E. 172.1.5.0/24
0%
F. 172.1.6.0/24
on a switch Atech network for example , there are 4 PCs connected as shown in the folloing figure . After the switch1 restarts
Host A send the first frame to Host C . what is the first thing that the switch should do ?
Host A send the first frame to Host C . what is the first thing that the switch should do ?
Anonymous Poll
8%
A . switch 1 will be add 192.168.23.12 to the switching table
0%
B . switch 1 will be add 192.168.23.4 to the switching table
69%
C . switch 1 will be add 000A.8A47.E612 to the switching table
23%
D . None of the above
what is causing R1 not to form an OSPF adjacency with R2 ?
Anonymous Poll
21%
A . the loopback addresses are on diffrent subnets
50%
B . the value of the deadtimers on the router are different
7%
C . route summuraization is enable on both routers
21%
D . the process ID on R1 is diffrent than the process ID on R2