Get in the zone! #DevNet Zone, that is 😏 New Cisco certifications have been announced for engineering and software… https://t.co/qRLmFKYNHI
@CiscoInterface
@CiscoInterface
Twitter
Cisco
Get in the zone! #DevNet Zone, that is 😏 New Cisco certifications have been announced for engineering and software - learn more! https://t.co/DoclrtGB51 #CLUS
Refer to the exhibit what is the most efficient summorization that R1 can use to advertise its networks to R2 ?
Anonymous Poll
27%
A. 172.1.0.0/22
36%
B . 172.1.0.0/21
27%
C . 172.1.4.0/22
9%
D. 172.1.4.0/24
0%
E. 172.1.5.0/24
0%
F. 172.1.6.0/24
on a switch Atech network for example , there are 4 PCs connected as shown in the folloing figure . After the switch1 restarts
Host A send the first frame to Host C . what is the first thing that the switch should do ?
Host A send the first frame to Host C . what is the first thing that the switch should do ?
Anonymous Poll
8%
A . switch 1 will be add 192.168.23.12 to the switching table
0%
B . switch 1 will be add 192.168.23.4 to the switching table
69%
C . switch 1 will be add 000A.8A47.E612 to the switching table
23%
D . None of the above
what is causing R1 not to form an OSPF adjacency with R2 ?
Anonymous Poll
21%
A . the loopback addresses are on diffrent subnets
50%
B . the value of the deadtimers on the router are different
7%
C . route summuraization is enable on both routers
21%
D . the process ID on R1 is diffrent than the process ID on R2
what is the most appropriate summarization for all of these four Routes ?
Anonymous Poll
31%
A . 10.0.0.0/21
31%
B . 10.0.0.0/22
0%
C . 10.0.0.0/23
38%
D . 10.0.0.0/24
refer to the exhibit below yuo have discovered the computers on the 192.168.10.0/24 network can ping thier default gateway
but they cannot connect to any on a remote network . which reason for the problem is most likely true?
but they cannot connect to any on a remote network . which reason for the problem is most likely true?
Anonymous Poll
62%
A . The 192.168.12.0/24 network is missing from OSPF
15%
B . The OSPF process ID is incorrect
8%
C . The OSPF area number is incorrect
15%
D . An ARP table entry is missing for 192.168.10.0
0%
E . AVLAN number is incorrect for 192.168.10.0