the print failed. Because I foolishly did not screw the vat down properly. I'll try again once I've replaced the film (or bought a new vat, depends how this goes)

https://news.1rj.ru/str/+x0IbObEsrDY2NDgx I made a channel for stuff that I find. Usually when on one of my model-website-browsing-binges

I'm trying to change the vat. Keyworld being TRYING. But the screw I tried to change decided to kill itself and stick itself to my little allen key wrench.

Welp. Another screw decided to be jewish and break my allen key wrenches. So there's another $70 down the toilet.

I can't even get one fucking screw out

$70 for a new vat. At least the prints will continue eventually

https://www.youtube.com/watch?v=_M2PQLoHueQ&pp=ygURbWFyayBrbmlnaHQgY2hhc2U%3D Still waiting on my vat. Have some whelptunes.

Gave the dragon onrament a basecoat of nurgling green paint. Will need to go flip it over and blast the underside too.

I just got an e-mail saying my new vat is shipping!

expecting the new vat today sometime

New vat is here. I'll install it tomorrow, and ready the printer!

I've connected this and the other channel to Whelpchat. https://news.1rj.ru/str/+6Ocll3NeSaQ0NTZh

GM! Time to go install the new vat!

Vat is installed, and now the traps are printing. I printed a four pack

Unfortunately we lost our rubber scraper used for cleaning the vats. I was an idiot and threw it in the cleaning liquid and sort of forgot. Now it disintigrated.

It's no biggy, we'll just mix the resin in the tank until we get a new one.

Half an hour until the Cucumber Beetle Synagogue pack is ready.

The trap only half printed. It didn't even TRY to print the bottom parts. Alright... alright, we can do a Mark II. And I can still use the tops.

I will print a mark II.