expecting the new vat today sometime

New vat is here. I'll install it tomorrow, and ready the printer!

I've connected this and the other channel to Whelpchat. https://news.1rj.ru/str/+6Ocll3NeSaQ0NTZh

GM! Time to go install the new vat!

Vat is installed, and now the traps are printing. I printed a four pack

Unfortunately we lost our rubber scraper used for cleaning the vats. I was an idiot and threw it in the cleaning liquid and sort of forgot. Now it disintigrated.

It's no biggy, we'll just mix the resin in the tank until we get a new one.

Half an hour until the Cucumber Beetle Synagogue pack is ready.

The trap only half printed. It didn't even TRY to print the bottom parts. Alright... alright, we can do a Mark II. And I can still use the tops.

I will print a mark II.

I'll print it tomorrow. This isn't over.

I'm going to go throw the Mark 2 in the pritner.

The MKII has successfully printed. It is washing right now.

The spookyposter guards the pumpkin crop. Any cucumber beetles that come anywhere near that are going to get piped in the torso!

To make a long story short, I need to print a Mark 3. (the printer screwed me again)

The mark 3s have been printed with thicker bases this time. This time I put them upside down while they dry off.

The Mark 3s are in the curing process. They will be cured and ready to be painted yellow later today.

Ladies and gentlemen, boys and girls, I give you the mark 3 cucumber beetle synagogue.

the things we do for our pumpkins...

GM. Reminder to resin printing frens: Make sure you put your knob on your build plate, or your print will get all screwy.